Other Security Subjects

I am trying to implement 802.1x on our network. We mostly have Cisco 7960 phones which don't support 802.1x. However I though you can configure a VOICE vlan and they can still work. however, the switch seems to put the phone in Guest VLAN because of ...

Hi all,We use a CSM ver 3.2.We'd like to open device manager for IPS from CSM and we've got th following error."sensor minor version is newer than supported version"and we cannot open the device manager;Could anyone help?

When i boot CAS it gives me this error!before login promptStarting perfigo: No env file found. IPsec not started.i have done the basic configuration of CAS by service perfigo config and when i use the command service perfigo restart it gives me the ...

Hia client has a small 877W Router running the Advanced IP Service IOS.It connects to the Internet using a standard ADSL2 connection with a single static IP address.Currently, Outlook Web Access is available from the Internet by NAT configured to for...

Hi AllI have enabled the NBAR on my router interface, and I can see the traffic on the interface protocol wise, now I want to catch the source IP eating up my bandwidth, how I can do this without using Netflow or something? Is there any way I can use...

We have recently upgraded the firmware on our ASA 5510 to V7.2(1) and have had some issues with this Inspect ESMTP command. Prior to the upgrade, it used to Terminate SMTP connections that it considered Malicious, which was fine as it appeared to be ...

Has anybody been sucessful in setting up Data Archiving from MARS to a Windows 2008 server? I asked TAC for configuration info like they have for earlier versions but it doesn't exist. I'm having an issue getting the MARS appliance to talk the the ...

Router 1800 with ehternet connected to side Switch with four servers.Serial port connected to internet.Is it possible to allow traffic to servers with their MAC addresses than IP addresses.

Hi Please view the attachment first.Basically we have a Cisco 6500 chassis with about 25 VLANS and around 25 -30 Access layer switches are serving as distribution layer switches in each VLAN.We now have a Web Proxy for each segment serving the users...

Should the Vulnerability assessment info be filled out for all devices? It takes over 3 minutes to load that each time I go to add a service. I have some servers with 21 ports open to the Internet, it will take hours to configure that one device.Than...

We are blocking the Remote admin using the access list , but it is found that users are changing the port numbers ( Default 4899).How we can Block remote admin totally on routers by using access list ?

Please suggest me Cisco firewall with 2-Lan ports and 2-wan ports

This error message is from a site-to-site VPN router. The whole error message is like:Aug 11 00:37:22.725 Japan: %HW_VPN-1-HPRXERR: Virtual Private Network (VPN) Module0/13: Packet Encryption/Decryption error, status=4610Aug 11 00:39:05.192 Japan: %H...