Other Security Subjects

Hi,I need to add static routes to the configuration of customer's CSC-SSM. Is there an official and supported method to do this ? I have add a script in the /etc/init.d/ folder that add the route through the "route" command. But sometimes ( I think w...

Hi,It is a design question.Customer right now has AS5300 with T1 over PSTN for RAS service. Now the customer will implement IP Telephony system using Cisco 2851 as voice gateway. Cisco 2851 voice gateway has Three T1s, two T1s to PSTN, one T1 as line...

We are in the process of designing our core, and for reasons of Multicasting, and isolation we my co worker has decided to use MPLS at a layer 2, Overview End users and remote sites will be VPNing into our core using DVI/VTI tunnels, after registerin...

For a given TLD (e.g., .org) is there a way to find all the netblocks associated with that domain (preferably in CIDR format)? I've been checking NSI, ARIN, etc. and they all seem to work only on a particular domain, e.g., cisco.com and not at the T...

Hi ...I am trying to find out if anyone knows the answer to the following.I have two 2800's each connected to separate SDSL lines tunnelling through to a 3030 concentrator. I would like both routers to load balance/load share and be on the same netwo...

I am have a connection between our VPN 3000 Concentrator and VPN 3002 concentrator. SOme of the PC's behind the 3002 can connect to the corporate Web site and mail servers, while some are timing out. All can ping these servers. Ping time to the parti...

What is the implication of the error message 106007 and how to zero down this message.

I am a little confused - were are configured b/w polices applied? Most people agree that they MUST be applied to a group, and to a LAN-to-LAN tunnel.But, a believe that applying to a group is optional - and it must be applied to an interface - normal...

HUB tunnnel: bandwidth 16000 ip address 10.0.6.9 255.255.255.248 no ip redirects ip mtu 1400 ip nhrp authentication xxx ip nhrp map multicast dynamic ip nhrp network-id 1 ip nhrp holdtime 600 ip tcp adjust-mss 1360 delay 1000 tunnel source FastEthern...

Hi forum,why when I use sdm, I can use username:cisco, password:csico to logon? Is there a way to change this?Thanks,py

Has anyone worked on this? Got some 3750 LLDP code so we could do dot1x and voice vlans with Avaya 4610 phones. I am able to get the 4610 to authenticate with my Cisco ACs 4.1 server, but I am having trouble giving the phone the voice vlan. I am tryi...

Hello, we are going to start rolling out SSL VPN to remote mobile users. My problem is we have an ASA that authorizes AD users via an ACS appliance. How do I get the mobile user to see an AD popup saying "You have 14 days until your password expires"...

Hello! Does Cisco vpnclient for linux support eToken?

I have a VPN 3005 setup to allow the SSL client login. 2 weeks ago we started having trouble with Outlook. The SSL clients authenticate and establish the tunnel just fine. When they try to start Outlook they get a message stating that the server i...