Other Security Subjects

Hi I am working at HP as a network engineer, I came accross a a traceroute output that was hard to conclude, when the traceroute command was used to a destination host(as server), the last lines from the output is pasted below hop 11 and 129 efgh.x...

Dear Sir/Madam, I configed two FWSM unit on two 6509 boxes. using failover. i made a test, ping pass the FWSM, I found it lost 8-12 packets when i reload active FWSM module in one 6509 box. i configed rapid PVST on two 6509. when configed...

Hi, i need to switch the configuration of a physical network interface to a virtual subinterface and one the same physical, can someone tell me how to keep the same nameif and the same ip address. See what i want to do :CURRENT CONF :HW_ID NAM...

Hello, I'm configuring a new PIX515E, and i'm a bit confused as to the proper fromat to use with regards to access-list/static command. I see 2 ways of doing things, and they both work... so if someone can explain which is the proper way, I'd appreci...

I tried to access intranet through Cisco VPN concentrator from Nokia 9500, first from Noka VPN Client v3.0-3 but failed with error synchronization failed. then using WebVPN, and also failed.Can you please help me in this regard, if anyone passed this...

Can i configure compression on the asa5500? I am trying to decide if i want to use the aim-comp for my 2801 or if i can configure something similiar on the asa. thanks!

I have strange situstion in wich same IP address can come on two different interfaces. One interface is location primary link end on second interface is backup link. Server to wich clients have to access is on third interface. Is it possible to confi...

Hi,has anyone an idea how to "activate"VLANs, when using Windows supplicant for802.1x and NAC-L2-IP?I know that normally NAC-L2-IP don't support VLANs, but maybe someone figured out a method ?with regardsharry

Hi all.I have 2 pix 525 (7.1.2) and i need to setup a very complex configuration about NAT. I explain better the problem.My internal networks, for example 192.168.1.0/24 192.168.2.0/24 192.168.5.0/24 192.168.4.0/24, need to reach 2 DMZ (192.168.100.0...

Dear Sir, Anyone have any real life exprience to perform the subject mentioned tasks? Please provide me the necessary steps to do the task?Our scenario. We've 10 servers installed with windows 2000server with SP4 , 300 clients host installed with w...

If I have the 126.139.5.225 default routes the GRE tunnel will not work from one the computers on the LAN side. Can anyone help me. no network-clock-participate slot 1 no network-clock-participate wic 0 no aaa new-model ip subnet-zero ip cef ! ip aud...

I have an ASDM CD and am trying to install to a new notebook running windows XP Pro, ...doesn't understand the file extension (.bin) and therefore run button not available, ...any ideas?