VPN

hithe vpn goes up, but the session ipsec turns out to be like the picture belowthe vpn goes up only if the traffic starts from the side of isa server why?under the ASA 5505 configurationResult of the command: "show conf": Saved: Written by enable_15 ...

                   Hi,I am setting up IPsec remote VPN for ASA 5505 using ASDM wizard and want to use VPN client for client machines. I have follwing questions:My inside network IP 192.168.0.1 and outside IP 162.212.232.174.1. what is POOL ip for ste...

gentsWe have a client which has a remote VPN conection to two sites. the remote VPN sites were managed by third parties. recently out company has aquired the sites and now they want to manage the devices at the remote site which includes CE router, F...

HI,I have installed a AS5400HPX device in our datacenter, and have ordered a T1PRI line from the service provider.Could you please let me know if T1 PRI is supported on my device. Check the Show Ver output below.cisco AS5400HPX (R7K) processor (revis...

I have been setting up l2l VPNs for a customer using ASA 5505s.  Recently we needed to setup a system through an ipv6 zone.  The customer did not want to run dual stack on the inside so we configured ipv4 l2l with ipv6 peers on the outside.  I really...

Attempting to configure AnyConnect for iPhone for on demand access.Have configured a Windows CA to provide the required certificates and have enrolled the 2951 with the CA. Have not been been able to get the configuration to work. Have gone through c...

Hi,Currectly 4 branches and 1 main site have asa 5510 firewall running with ios7.2.Main site asa is running site to site VPN 4 site and remote access vpn.I try to update asa 5510 ios from 7.2 to 8.3 on main site.After upgrade to ios 8.3, all 4 site c...

Hello,Our customer is complaining with his VPN connectivity, "During travel, I often have issues with the VPN connection. It often disconnects and then cannot connect again. I sometimes find that I have to shut my laptop down and reboot before it wor...

Dear Sir,iam facing strage problem is we have site to site tunnel established phase 1 is comleeted but there is no traffic on responder side and when i debug ipsec iam getting the fallowing eoor[IKEv1 DEBUG]: Pitcher: received a key acquire message, ...

My father recently passed away and I found a large sealed envelope from CISCO in some of his belongings.I open it up and there is a welcome letter and two disks that are sealed.Says:Congratulations on purchasing Cisco IOS WebVPN. This Cisco IOS softw...

Hello, I'm having issues establishing a VPN between a Cisco ISR 857 and ZyXEL USG 100. I've deleted and readded the VPN a few times (via SDM and manually via SSH), ensured the settings are correct both sides but still no luck. Seems to pass ISAKMP ph...

Hi experts,Need your help on below detail.Head office ASA5520========>EZVPN<=======cisco877 Branchconnectivity from branch office to head office is fine but branch office users are not able to get internet locally. kindly look into below mentioned co...