XR OS and Platforms

Hi Is there any particular reason why ISIS on tagged sub-interfaces (both single- and double tagged) doesn't get a CoS value of 6 in the frames?I know, I know... "Why would you run ISIS on a sub-interface?"Indeed, but I have a rather special scenario...

Hi all,I tried to make one ASR 9006 two RSP Mgmt interface (Mg0/RSP0/CPU0/0 and Mg0/RSP1/CPU0/0) connected to one local management switch, since we don't have dedicated physical separated Mgmt network, so this local switch need to be piggyback into t...

Hello all We try to understand aspects of the behaviour of ASR9K for PPPoE sessions. Specifically we see that after retraining of xDSL CPEs (and for as long as the old session has not been timed out) subsequent PPPoE session initiation attempts from ...

G'Day, I'm just trying find the difference in feature set between a few different product lines at the moment.  I'm looking at the ASR9K BNG reference commands Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Refere...

Folks, Commonly in XR networks, reliability is very critical (always). Reliability needs to be high and convergence needs to be fast. There are several ways of detecting network failurebut not all of them scale. There are mainly four components of ro...

Hi Xander,How’s everything going?One of the coolest things about the routing plane there could be in IOS XR/ASR9K routers would be have dual/redundant independent RSPs. Could you tell me if there is any prospect of having the  feature of the Full ISS...

so, what truly does it mean in a lot of our documentation slides (networkers, courseware, etc.) that describe the functionality of the asics and cpu on an asr9k line card.      specifically, in the 'box' containing cpu tasks, functionality it lists  ...

Hi everybody,I ask a simple question. I'm using asr9k ver 4.1.2 I want to logging http and https traffic. I want to use squid wccp mode. Is it possible? I can try to wccp configuration but I can't see wccp command on the xr software.  

Hi, I need to create a policy map and class map/service policy to limit the amount of bandwidth that can be used on one interface both in and out. I need the cap for the bandwidth to traverse this circuit to ne 10 Meg. the IOS xr version we are using...

I am wondering if anyone has any additional information in regards to SSH NETCONF as referenced in the below link, and additionally in regards to this capability on IOS XR-V. Thus far I have not been able to get this working. https://supportforums.ci...

Hi guys,I'am trying to enable SSH on my 3550 EMI switch and my IOS version is c3550-ipservices-mz.122-44.SE6.bin which I uploaded to the switch today and Cisco says it has crypto feature. I can't enable crypto and SSH. Can you help or give me a hint ...

Hi all, I have an issue asr9k that traffic output not balance, i already try using command "bundle port-priority", "bundle load-balancing hash src-ip" or "bundle maximum-active links" but still not balance for output traffic, is there anyone have the...

Hi,We have ASR 9006 and use RADIUS to create unique shared-policy-instance for each of our subscribers.Radius Access-Accept message include,sub-qos-policy-in=GOLD_SERVICE shared-policy-instance spi_{uniqueID}_inwhere GOLD_SERVICE is the policy-map. N...