Network Management

Dear friends,I am unable to generate any report on EoS/EoL hardware report using a valid CCO accountIt works though with EoS/EoL software report.The message i get when i click on the job is as follows:Unable to get data from Cisco.com. Check Cisco.co...

How can I configure LMS 3.2 to show us if any of our 50+ router's QoS policies are dropping packets?  Specifically we have output policies applied to our WAN interfaces and I would like something that will tell me if any of my routers have dropped pa...

Hello everyone,I have router 1801, I puted a password and made disable recovery mode. I forget my password now.when I hit a pause key to enter in ROMMON mode it gives me this messageUpgrade ROMMON initializedPASSWORD RECOVERY FUNCTIONALITY IS DISABLE...

Hi,I was locked out one of my routers.  I cannot access it via Telnet, SSH, TFTP, SCP, etc.  However, I remembered once I reconfigured the router via SNMP community string.  Does anyone know how I can change router config via SNMP community string us...

Dear All.,found out the the Cisco network assistant version 5.2 display unsupport product after install the Cisco Catalyst 2960PD-8TT-L,, However, it can be handle the normal setting through this S/E but icon could not be display and show the message...

I thought this was resolved long ago but I still see in RME 4.3.1,  LMS3.2 on Solaris 10. I see partial failure for several switches with the following error.We do allow telnet to the devices but ssh is allowed. NEtconfig works using ssh without any ...

Hello,An upgrade has been done on the switch however the RME Software Summary has been not updated on the LMS Portal.Herefafter , see the detailed of the view and the reports sorted out.The report shows that the equipment is upgraded in 12.2.(53).The...

Im getting this failure message when i run the end of life report on RME.Report Name :EoS/EoL Hardware ReportCreated at :Jan 05 2010 10:37:30 WSTReason for Failure :Unable to get data from Cisco.com. Check Cisco.com connectivity. Try again laterThere...

Hi,I need some assistance in locating the  mib/variables to allow me to add and remove vlanvirtual interface on Catalyst 3759G. If I understand correctly CISCO-VTP-MIB can not  carryout this requirement.Is there another way of accomplishing  this usi...

Hello,I am using the Composite Device Health EEM  that sends out an email notification once my interface is or CRC errors reach a particular threshold. The problem I am having is that I have to manually do a 'clear count' to get these emails to stop ...

I use terminal-server. all my line are configure correct . When I telnet to the devise x.x.x.x 1000 it does ask me for user and pass. I put in the user/pass and I get authentication failed. .. When i telnet to the that devise w/ out terminal server I...