Network Management

I am new to LMS 3.0, and would like to know if its possible to add a third party device (non Cisco) to the LAN.If not, what would the workaround be?

Hi there,I was doing a NetConfig job just now. I made two jobs, and they set to run immediately. Now for the first time I get the error: "ERROR:RME_CDL1022:Failed while locking the device" on few devices. When I saw this error I thought it could be b...

hello,is there an OID which I can use to get a snmp-request from a Cisco ubr7200 Series and get a result like equal to the output of the command in privileged mode "show cable modem summary" ?

Does anyone know how to do a path analysis with the LMS 3.1 bundle. They are taken out of Campus Manager bundled with LMS 3.1 Thanks

We have several ASA 5520's that are only accessible by 1 of 2 methonds:1. Through the outside interface, using only SSH.2. Through the inside interface, but having to hop through an internal routing device (usually a 2800 series router). Telnet, ssh...

under line con 0, changing speed to 115k or anything else such as 9600kbpsc generates error: Failed to change line 0's speed. Does anyone know how to fix this?

Hi, I am trying to setup E-mail Notification in LMS. I am not able to see all the devices listed in the notification groups in DFM,same as user defined groups in Common Services in Ciscoworks. How to make sure that all the devices and user defined g...

I am trying to configure the router to send configs to my tftp serverI would normally use archive config but the command is not available.I am running a 2621 with this imagec2600-i-mz.123-26.bin (IP image).Anyone have any ideas?

Hi,We are using DFM 2.0.8 with LMS 2.6.I wish to create a custom group wich will contains only 4 interfaces (trunks) from 3 switches.Or create as many groups as needed in order to be able to set a specific threshold for only those 4 interfaces.Is it ...

Any know where on the Cisco.com website the "NAM software K9 cryptographic patch " for the NME-NAM-80S is?I have looked several times and keep going round in circlesAny help is greatly appreciated.Thanks,C.

I am trying to create a custom rule that will allow me to increase the %Utilisation threshold on specific trunk ports on a number of switches. I cannot get the syntax of the rule to be accepted can anyone help me with this? The rule I am using is cop...

Is possible to change the default location of all default LMS logs?? I changed only the location of syslog.log. I'd like to change the location all other logs too. Thank you.

Preved!I need to change admin status of neighbour through snmp. I have typed the next command:C:\snmp\bin>snmpset -v 2c -c SetSNMP 192.168.132.2 1.3.6.1.2.1.15.3.1.3.2.2.2.2 i 2(2.2.2.2 - ip address of my neighbour)But have got the next error.Error i...