Hi , We are using the LMS 3.1 . Here we have around 20 numbers of Notification and Email notification group .Recently we have got a complaint like some users ( or IDs) in a particular email group not receiving mails . So we have checked SMTP se...
Hi,Since customer has update RME 4.0.6. He has many devices which config failed partially with this message:Protocol ==> Unknown / Not Applicable CM0056 Config fetch failed for Amberieu Cause: CM0204 Could not create DeviceContext for 653 Cause: CM0...
Hi Teamplse let us know any document containing supported devices for CISCO VIEW MINI-RMON MANAGER.ALSO HOW WE CAN CONFIGURE THE SAME ON LMS.RegardsVaibhav
I would like to update the hostname on 175 devices to match the device name that displays in CiscoWorks. Is there an easy way to do this? If so, how?Thanks!
Quick question.If I order a MCS7825-H3-ECS1 server with the Unity System Disks, can I load LMS 3.1 on to it and have it run , or should I just go out and purchase an HP directly with Windows Server on it?Thanks.
I am trying to tidy up a customers inventory within LMS 2.6. I have discovered a number of devices such as routers that have multiple IPs configured. Ciscoworks seems to discover these addresses and then presents me with a device for each IP addres...
Hello,I started with LMS 2.2, then got an upgrade service release to 2.5 and later on upgraded to 2.6. Now, I have an service release to 3.0 and this can only be installed on top of LMS 2.6. However, my existing server is below the minimum hardware r...
My setup is LMS 2.6 in Solaris 9, CS 3.0.6, CM 4.0.10, CV 6.1.5.I have problems with port security in Ciscoview for the 2960G switches family. I have the latest device patch for the device. I can carry out whatever other operation, but when I choose ...
Is there a possibility to read the firewall configuration over snmp and write it down to a tftp server? The customer has two firewallsystems and want to save the configurations daily to a tftp server. He has a linux server to provide the snmp and tft...
