Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 

Network Management

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Start a conversation

Netflow analyzer

I collect netflo records with flowd opensource netflow collector. Flow version is 9. I would like to do some analysis on the collected data. Does anybody know a very good tool for this issue? If it's possible I prefer opensource..Thanks your help in ...

farkascsgy by • Level 4
  • 1711 Views
  • 11 replies
  • 0 Helpful votes

Resolved! CW LMS 2.5 Syslog Messages

Hi All,I am trying to setup a Cisco VPN 30xx Concentrator to send its syslog messages to our CW server but so far I am unsuccesful, can anyone give me some hints or ideas what might be causing the problem, Thanks.

scbne by • Level 1
  • 1174 Views
  • 4 replies
  • 0 Helpful votes

Using Network Registar to support DDNS

I am new to CNR and I have the DHCP section working but cannot seem to get the Dynamic DNS portion to work. Do I need to have the DNS server piece working? Does the DNS server have the primary server for my zone? I would prefer the DHCP server just...

ggladney by • Level 1
  • 1392 Views
  • 1 replies
  • 0 Helpful votes

SNMP on RPS

Hello all, I wanted to use SNMP feature of Cisco RPS 675 but i dont know how to connect it and use the SNMP feature. could some one help me. I will be very much thankful towards u.Thanking You.sham

Resolved! Telnet and View Config on Device Center

I cannpot telnet on devices when using the Device Center although the enable paassword is correct. However, when ping ang trace route, it works fine. Trace route uses the Serverś IP address as a source.View config also has error. It looks for the old...

ariesc_33 by • Level 1
  • 1168 Views
  • 6 replies
  • 0 Helpful votes

IP SLA measurement using Cisco SAA

Hi, I have problem with the source or shadow router which was used as the source router for the IP SLA measurement. The test and oncfiguration being setup through an exernal application called Concord eHealth. I had noticed error messages tied to CP...

josephn by • Level 1
  • 1280 Views
  • 5 replies
  • 0 Helpful votes

Resolved! RME-Config Collection and passwords.

We currently have ACS setup on all out network devices. This is working correctly.I am trying to collect configs from my devices using RME. IEach device fails "Failed to make telnet collection.I'm sure they are failing because the device is looking f...

cpopour by • Level 1
  • 1379 Views
  • 9 replies
  • 0 Helpful votes

setting up ntp server

I'm trying to configure an internal ntp server for my cisco clients to use rather than having them use a public ntp server. I've followed the steps found athttp://support.microsoft.com/kb/816042/EN-US/and set a test switch to use it as its ntp serve...

View All