Other Security Subjects

Requirement: Multiple small vlans behind a single shared firewall.Current proposed setup: Pix or Nokia FW-1 firewall connected on the outside interface to Internet Backbone providers, inside Lan interface connected to 2948 switch to provide multiple...

Hi, I have a 2600 router which all of a sudden tends to drop incoming email packets after a period of time (like an hour or two). The only temporary solution is to reset the router and then it passes email for a while until it stops passing again. Do...

Is anyone out there populating an external database with IDSM logs? I would like to somehow populate a PostgreSQL database in as close to real-time as possible. Anyone doing anything like this? Is it even possible? Any information would be greatl...

Can anyone advise on the Cisco MIB for changingthe enable secret password.Regards

I would like to know what it means when "ping inside <IP Address>" means.Does this mean I can only ping inside hosts, or does this mean that I can ping FROM the inside interface to an outside host.If the latter is the case, and I cannot get a reply f...

heeloi am ccna and done B.E in computers ...have a littel patrical exp. in networking .....i just wht to know about the new cisco security track" how worth it is ...etc...hopeing for a reply Amit.

Hi I have a 2620 router and we bought a AIM-VPN/BP module. The router's existing IOS/Hardware configuration is :Cisco Internetwork Operating System SoftwareIOS (tm) C2600 Software (C2600-IK2S-M), Version 12.0(7)XK1, EARLY DEPLOYMENT RELEASE SOFTWARE ...

Hi How to remove RADIUS x-auth from vpngroop on the PIX515,ver 6.0? thanksben

If I have a direct external ip address to internal ip address NAT mapping do I need to do any other configuration on my 3640 router assuming I have all the ports required enabled. ?

After some initial troubleshooting it appears that my remote VPN device is "too busy" to service my phase 2 "rekeys" from my local VPN device. I see the following in my debug output ..."Death by retransmission P2"Does anybody know if I can configure...

I have been trying to setup an IPSec Tunnel between VPN3000 and Checkpoint Fw1, but it doesnt seem to work. I have done the setup based on Cisco documents. Also the box to which i am trying to setup the IPSec tunnel with is behind another PIX FW whic...

Can I use 2 static routes to nat 2 internet t1's coming into our building? I was thinking of putting the nat inside command on the ethernet and the nat outside command on the wan interfaces and creating 2 nat pools for each of the address blocks...do...

Hi all,Can anyone give me some advice on the following please.If I have: server -> PIX -> routerand I want to allow snmp from the router back to the server I believe I need to create a static from the ip of the router to the ip of the server?ie:stati...

It appears that the IDS services on my CSPM 2.3.3i(Windows NT) machine is no longer running. I have not been able to discover why these services won't start. I was wondering if anyone has experienced this type of problem before and could offer any su...

i lose access to mapped network drives after installation of vpn client. can anyone help? thanks