Other Security Subjects

HiI have a pix firewall. The problem I have is when I ping a server in the DMZ, I get the following response in the logs:305005: No translation group found for icmp src outside:y.y.y.50 dst dmz2:webserver_1 (type 8, code 0)Just to add I not NATting a...

I have succesfully blocked all file sharing softwares except Lime wire because there is no PDLM available on cisco site. From where i can fetch this PDLM. Please help in this regard.

I'm trying to configure an ASA5510 and when I add this: static (INSIDE,DMZ1) 10.3.200.2 10.3.0.2 netmask 255.255.255.255I get this: INFO: Global address overlaps with NAT exempt configuration.I don't see the overlap. I have attached the running conf...

Hi!I'm trying to make a customer to access his email server (POP3) trough WebVPN on his QTEK PDA. I read that port-forwarding is not suported. Is this true?Regards,JP

Has anyone configured HP 2600 series switches to work with CS-MARS? We configured them as generic routers, MARS ses them, but no SNMP traps seem to be sent.

HiHave a cable modem, connect my pc in and of course can get a specific UDP port opened. But when i connect my 501, all my ports are shielded, and that of course is good. How do i open UDP XXXXX from outside and in to my network and a specific host?c...

hi i need the link from where i can download rme 3.5 for vms 2.3 , also tell me whether i can install rme 4.0 with vms 2.3 or not.

Hi There,I have a server which needs to SSH to my PIX FW, this server used to SSH successfully until I added static translation to it in my config. The related PIX config is:name 172.16.2.33 SecurityServer2static (inside,outside) 212.93.195.26 Securi...

%PIX-2-106006: Deny inbound UDP from 10.22.189.22/137 to 10.22.189.255/137 on interface VPN_Private%PIX-2-106006: Deny inbound UDP from 10.22.189.22/137 to 10.22.189.255/137 on interface VPN_Private%PIX-2-106006: Deny inbound UDP from 10.22.189.22/13...

Hello,I am trying to log all activity on my routers. I have logging levels all set to debugging. Is there something that I am missing? Any help would be appreciated!Thanks,Adam Filkins

Hi,I recently taken over a site where the default reouter is layer3 switch (192.168.32.2 /24). A proxy firewall was installed previous (Borderware) which worked fine. However switching to a pix firewall (192.168.32.1) seems to have caused a problems ...

I did a factory reset on a 5510 that we are currently testing before deploying and now I can not get back in. No console cable, no factory dhcp addressing on the management interface. NADA. Any suggestions??

Hello,I have run into a scenario where the objective was to only allow a router to connect to a 3550 port if the router had a specific IP address assigned. I know how to do port security with a mac address but how can this be done with IP address? If...