Can i know that can FXO cards used with EPABXAnd can FXS card be used with EPABX?If yes then wat is difference between both ?Are FXO and FXS cards used with Dot Line?RegardsAuromira
Dear Net Pros,On my serial interface of my AS 5350, I am having the following output as given below. The 5 minute input rate is half of the 5 minute output rate. Can someone suggest how I can fix this problem. I am currently also having access-lists ...
Dear Net Pros,How I can know if the calls coming from an originating gateway to our terminating gateway are getting dropped due to insufficient bandwidth??? Also if there is insufficient bandwidth on our end then where will the originating calls actu...
cRTP used to compress the IP/UDP/RTP header from 40bytes to 2-4 byts. Lets take a senarioCE1-R-R-R-R-CE21. now crtp hs been enabled on CE1 and CE2. How will R come to know that ip address of the destination(IP headder is compressed).2. Or should crtp...
I have several branches that require VOIP, PPP Multilink is a solution but if I have more than 1 branch I need to have ip unnumbered to my ethernet interface. I don't really want to do this.Please may I have an alternate solutionThanksNeelay
Hello Net Pros,I have configured a MRTG system to give me the traffic analysis of my AS5350 Gateway's serial WAN Interface. Now in my graph the "Current In" value displayed is always smaller than the "Current Out". The same is for "Average" and "Max"...
Hello AllI have an AS5300 , I reciving calls from a pbx (teles ) and im sending the calls to ip ( voip) , but if i make a dial-peer pots with the same destination patern the call will go back to E1 and not to voip (and the voip dial peer is configur...
I can see that the requirements for CSPS is Redhat 7.1Do anyone know if it will it be supported on 7.3 or Redhat Enterprise Linux 2.1 or 3.0 ?? Since we're not using 7.1 anymore !Regards
hi,i have a 5400 working as integrated slt...the c7 link aligns at times but drops after a few seconds. we have looked and avoided every posible hw and sw bug (there were a few, especially one regarding the e1 cards) and keeps happening.anybody have ...
I have one Origination GW with 2 IPs(256kbps each) on Fastethernet and ethernet. Let say I assign 1.1.1.1 on F0 and 2.2.2.2 on E0 then ip route 1.1.1.0 255.255.255.0 "default gw of 1.1.1.0"ip route 2.2.2.0 255.255.255.0 "default gw of 2.2.2.0"Now the...
I have two 2600 series routers with FXO as well as FXS ports at 2 different locations. I want to connect it to PBX and have VoIP between the two locations.I need the solution how to connect them and configure the routers.
hi I have a question relating to a problem I am having.If a pbx does not support en bloc (ie pushing the number accross in one go) but only putting out digits one digit at a time (overap) how can I get the router to see this?I have a connection with ...
Hi GUY !!!Pls help me known???My company registed 64Kbps/CIR 32Kbps for Frame Relay connection between two offices. We configured 2 lines voice over IP for phone and fax, reserved bandwidth for each line is 16Kbps. I would to know when nobody make a ...