Hi experts,Could someone guide me towards configuration template for achieving MGO for VRRP.I have two ASR9006 connected to a there respective switch on a 1Gig link. The switches are interconnected and passing the VLANs.The 1Gig interface is configur...
I have an issue with stale route which can only be resolved by using the command 'clear route ipv4 unicast <prefix>'We have been running this IOS verision for a while and this is the first time that we have seen this.Anyone seen this issue before?
Hi all,Does something need to be configured on a POS interface hosted on a CPP (/SIP700) to enable drop statistics or is this out indicative of a hardware limitation?Thanks,Terrysh controller pse qfp int pos0/1/0/1 statistics drop location 0/1/CPU0 W...
Hello expert,If i had asr9922 with 4xpower module v.2 should i install all modules in single power shelf or each shelf each power module? What is pro and con?Thanks,Marit
Hi,I have a lot of subinterface for customers. I want to use rate limit for subinterface. But I didnt see the rate limit command on asr9000 interfaces. Then I try to policy map so devices said 8 queue limit. How can do this?
Hi Guys,I have upgraded a2 X ASR 9001 routers from 4.3.1 to 5.1.0, everything seems to be ok but they are not in production so haven 't had a propoer test.My concern is that I am getting the below erro whenever I boot them:RP/0/RSP0/CPU0:Sep 24 14:49...
Hi all,So if I have the following set up in IOS: interface GigabitEthernet7/0/0.265 encapsulation dot1Q 265 ip vrf forwarding test ip address 1.1.1.1 255.255.255.252 ip verify unicast reverse-pathendip route vrf Apollo 2.2.2.0 255.255.255.248 1.1.1....
Hi.I need some performance and scalability numbers and limitations of ASR9k ISM card for NAT44. Documentation says "at least 10 Gbps full-duplex bandwidth throughput". Some other presentation are mentioning 15 Gbps but I think this is probably pps li...
I did one FP-140 replacement , while OIR i've noticed following logs . i'm wondering what do these logs mean. Anyone have insight ? "Unexpected version of classic configuration memory (0). Please save contents of nvram by using classic image, and for...
Hi all,I have a problem of Layer 2 connectivity which is like this:I have a 3750 switch, ASR 9010, ASR 1006 that are connected like this:Switch 3750 --------------------- ASR 9010 ---------------- ASR 1006The problem is that I cannot ping from Switch...
Hi all,With an NP-based linecard, lots of stats are available that can help identify the cause of droppped input frames by using the show controllers np counters command. Is there an equivalent for SIP / SPA based cards?Thanks,Terrycommands
Earlier this year I implemented a new SP network with 25 ASR 9k routers, a mix of 9001 and 9006. I created a tar file with the required packages, based on 4.3.0, and I used this same tar file to upgarade all the routers, without any problems.Now, I'm...
Hi I am trying to find a decent set of docs regarding the ISIS Loop Free Alternates on IOS-XR 4.3.1 for the ASR9K platforms.There seem to be lots of parameters to the CLI that dont appear in the documentation.I have for example a node with two uplink...