Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Hi Below are the problems we are facing in the LMS, 1) Inventory failure: Inventory failed - 71 devices Inventory success - 421 devicesWhile checking the credential verification report it is showing Wrong credentials. But for this same device c...

vaibhav-g by Level 1
  • 427 Views
  • 3 replies
  • 0 Helpful votes

I am trying to set up some pulling of CPU, memory utilization and environmental polling. I have the pollers set up and used the appropriate instances, but my portlet says that there is no data to display. Trying to figure out why.

jlhainy by Level 2
  • 1948 Views
  • 30 replies
  • 0 Helpful votes

Hi, I have installed LMS 3.0.1, mini RMON dont shown my devices (7606s), the error displayed is: "MessageFailed to open Mini RMON manager for this device.CauseMini RMON manager may not be supported on this device.ActionPlease check the Mini RMON pack...

cdiaz by Level 1
  • 665 Views
  • 3 replies
  • 0 Helpful votes

If we set the authentication failures to create a log entry, is there a way to only allow those log messages to be sent via the “snmp-server enable traps syslog” command?We really don't want traps sent for all syslog messages.Please suggest !

georgeef1 by Level 1
  • 440 Views
  • 1 replies
  • 0 Helpful votes

Hi,we just started rolling out UTLite for user tracking. Some of our hosts run Windows Vista. I found in the Campus Manager User Guide that Vista is not supported for this.We would like to know:a) When will Vista and Windows 2008 be supported for UTL...