Network Management

Is there any potential pitfall in assuming vlan.dat is the only file stored in const_nvram on the cat6k?

The SystemOID is 1.3.6.1.4.1.9.1.560 The version of RME I am using 4.0.4 we verified the configs as with all other the devices we have in CiscoWorks but we get an error RCMD Sev4 RCMDDNSFail DNS hostname/IP address mismatch. 172.18.20.11(CiscoWorks) ...

Hi!I've difficulties getting an usable response while asking for the status of the RPS. These are the objects I have tried:CISCO-ENVMON-MIB::ciscoEnvMonSupplyStatusTable.1CISCO-ENTITY-FRU-CONTROL-MIB::cefcFRUPowerSupplyTable.1CISCO-C2900-MIB::c2900In...

Some of my routers report their S0 interface address on the ANI Discovery Matrix and others report their FA interface address. I have the local routers FA interface set as a seed device on all of them because they all have firewalls in front of the l...

hi guys,i dont have a very good background on snmp ... !!i have 2Cat6500 with plenty of switches as edge, i have intsalled LMS ver 2.6 and would like to start discovering the whole network devices (switches and around 20 Routers)i want the best pract...

I have the following environment:- Ciscoworks LMS 2.6 running on a Solaris 9 box- Single sign on is Standalone- CW is working only with local data, no DCR Master/Slave structure configuredThe problem described below happens ONLY using Internet Explor...

What is the OID number and its type&value that I can disable aaa new-modele command on the router

Hi all ,I have E1 line & ATM technology in my call center setup.I know that E1 has 32 channels & its BW is 2.048 Mb but my problem is my output after ATM is 1724 Kbps & i want to know that how this 1724 comes , what is the calculation for this 1724 K...

Can any one tell what is sparse mode and how can i confogure that mode

I have three issues:1. I am showing a different list in Device Fault Manager than in DCR.The DCR list was created by entering everything in manually.In DCR I used the Loopback Interfaces as the TACACS interface and the IP Address of the devices.Also ...

I noticed these errors while looking for a config sync problem.They just started on June the 10th. I also see the dcmaservice log is not showing successful config fethes from that date on, but the jobs are showing successful and the configs are being...

Is it possible to create VPNs to managed CE devices without a out of band interface and if so how do you go about it?ThanksMartin

I want to check the total switches ports which are not using for certain period of time (For example - 90days).I have tried to use CWSI (RME). It can generate the report called "Switch Port Usage-Unused Up" and "Switch Port Usage-Unused down", but it...