I just recently cleared the counters on this, and I see this below. Customer states the internet is 'slow'. They have a full 100mbs connection no policy added to interface. I have increased the hold queue as you can see, but still have drops. My ques...
Hi gurus,will there any problem if i used GBIC to SFP with a short distance around 10m usign an LX type for both? What would be the implications on using different types on different distances?tnx.
NetPros,We have a stack of 3750 (5 switches). There are two servers (on Fa5/0/37 and Fa5/0/38) that need to communicate with eachother. The requirement is to send the packets with size 2048 (fragmentation allowed).When we ping from one server to anot...
Dear All,I am having to mix fabric and non-fabric enabled line cards on a single chassis.These are my line cards:WS-X6704-10GEWS-X6408A-GBIC WS-X6148-GE-TX What's the maximum expected throughput in running with mix fabric line cards ?Also, what w...
Hi all,I have the folowing scenario:Two 7604 conected back-to-back with a WS-X6148-GE-TX module. the vfi show up the ldp neigbhor show up but the on the vc detail i have :Destination address: 2.2.2.2, VC ID: 100, VC status: up Output interface: no...
Hidoes anybody experienced problems in vlan remapping on Metro 6524 ?This is my machine sh verCisco Internetwork Operating System Software IOS (tm) s6523_rp Software (s6523_rp-ADVIPSERVICESK9-M), Version 12.2(18)ZU2, RELEASE SOFTWARE (fc2)Technical S...
Need to configure new 15 site Metro Ethernet network with this physical topology:x=x=x=x=x=x=x=x|oooooooooooooo|X====X-X==x==X|oooooooooooooo|x======x======xx=7604, X=7606= 2x 10Gb Ethernet- 2x 1Gb EthernetThis network will provide metro ethernet ser...
I need some help configuring QOS on a 6548 blade with sup720. I am a metroE subsriber on a port. I have a gig port speed with 100meg service. I have 25meg available for priority queue. I need to limit my aggregate output to 100meg. I need to mark pri...
Hi.Can I generate a big number of mac addresses from any Cisco Switch, How can I generate that Macs, I Neet to simulate an attack in a Switched network in a simple manner to prove that they are conntrolling this kind of attacks.Thanks, Regards
Hello,i have 2 simple questions :)Is it possible to stack the ME3400 switch? If yes, what cable do i need to use in this stack.If no, is it planned for future?I really appreciate your help (replies) on this.Regards.
is there a preferred router for Ethernet WAN applications 10MBS, 100 MBS? Running BGP going to MPLS network? Can a 1841 work? Or is there reason to move up to 28xx or 38xx? Is it possible to avoid the Router and just plug in to a Core Switch like 651...
Can I use a L3 switch such as 3560/3750 to terminate a Metro Ethernet link of say 100 Mbps or do I need a higher end router for the same?If I can use a switch are there any performance tradeoffs?