Hi,I have been attempting a restore using the restorebackup.pl script but it was repeatedly failing 70% of the way through the RME restore.I discovered that the script was changing the directory permissions for /var and /var/adm from root:sys 755 to ...
Hello,when i create a Netshow job,it is always gives me failure status but when i click on the JOB ID to see workorder and then when i click failure it show me the command output.pls suggest .Thanks
Hi,I have an issue deploying a policy with QPM; The policy I am deploying gets stuck on the "in progress" state and never deploys properly. Looking at the CLI of the router I can see some of the policy commands have been entered from QPM, but the job...
Is there a document that gives a better technical explanation of the discovery process? Thedocumentation I've found so far is fairly superficial.I'm testing discovery with a new LMS 3.2 installation and so far it seems like I will have to enter every...
Hello,When i look at my devices in the DCR, some of the devices have their ip address as the hostname.Some device are ok and are showing their hostname as the display name.in global settings the preffered DCR display name is the hostname.What might c...
Got this question about the "Link Duplex Mistmatch".I have a 6509 and a 3560E connected with a 1 gig trunk.Now, the CW2K reports a discrepancy for this trunk, "Link Duplex Mistmatch".The 6509 and the 3560E has an 1000BaseSX SFP3560E-port configinterf...
I have a csico 850 touterMy router has 2 interfaces:Vlan1 192.168.1.1Dialer0 192.168.2.1 I want CW to use dialer0 as the primary interface. Dialer0 has cdp disabled, is that the reason CW use VLAN 1interface ins...
Hi folks, We are using LMS 3.1, in this we are using IPM 4.1, I am not getting how to configure it and start to work by it. Can anyone tell me some idea abt configuring the IPM.
Hi,DFM doesn't seem to recognize the 2960 PoE switch ( Catalyst 2960-48PST-L). The status of the devices is unknown. I tried the software and device update but it prompted that there are no updates for DFM. I am using LMS 3.1. What should I do?Thanks...
Hello,I'm trying to better understand how UTLite works and how it interacts with CW.We use a tool called "Desktop Authority" to manage policy on our PCs. When a user logs in, they authenticate to AD, then desktop authority takes over and works its ma...
Hi,I have a problem with RME to reposit Catalyst 2960 IOS. It does not find the IOS in the flash. It works fine for all other devices but 2960!I receive the error message SWIM0014. I collected the inventory successfully but still do not see the IOS. ...
I want to enable EEM. Trigger event is to down L2accessport in Another Switch. SwitchA,SwitchB assigment Tunkport(g1/1)and accessport(g1/2)Trunkport(g1/1) is directly connected each other.When it detects a down accessport(g1/2) in SwitchA, Enable EEM...
