Network Management

Fetching configuration from ASA 8.0.X, RME 4.1.1 produces a truncated configuration (using package version 4.1).Any ideas?Thanks.Andrea

Why this devices appear like a box with a "?" symbol inside?If when I do a cisco view of then I can See the complete device picture.What I need?¡I attach a print screenThanks very muchJorgelina

Hello , Dears all,An LMS 2.6 run with CAMPUS MANAGER 4.0.12The UT has been launched as well,before a data collection and discovery.The only thing is that hostname has been not found on the campus manager report.Is the problem is still the same under ...

Hi all,I just performed a migration from one server to another (same version of OS, LMS, and application modules) After the restore, I ran hostnamechange.pl. The log files look clean and things seem to work OK. Before the migration I loaded a 3rd p...

Dear Concern,Can I install LMS and CSM in a same windows server.Please response.RegardsImran

Hello, I have recently discovered the HUM Interface Report, however I have found that it only reports data for the last 1 hour. Is it possible to configure this report for a custom time frame. I access the report from cisco view, and right clicking ...

I am running LMS 2.6. I noticed when copying an IOS to a device using Ciscoworks, it erases the current IOS, and then copies the new one flash. Is there a way to have ciscoworks keep the current IOS in flash and just write the new one to flash. Also,...

Is there any tool that can alert based on a user-defined percentage/number of access ports that have gone down over a specific timeperiod on each switch, relatively easily out-of-the-box (vis-a-vis requiring heavy consulting/pro service customization...

In RME collection status under config archive in partially successfull tab i am getting this error message " Command failed VLAN Config fetch is not supported using TFTP. Could not detect SSH protocols running on the device VLAN Config fetch is not s...

I got the below error message in config Archive in RME "CM0056 Config fetch failed for 172.18.0.23 Cause: CM0204 Could not create DeviceContext for 231 Cause: CM0206 Could not get the config transport implementation for Cause: CM0202 Could not acces...

Hi,I took the time to layout my topology map and saved it. It was fine forabout 3 weeks and now it is gone? How can retrieve the map I had? The one that shows now has all device layed on top of one another.Please check.Thanks

Can anyone suggest a cure for the following. Last week the inventry job went wrong and filled the entire disk on the server with a 110gb log file.I cleared that off and since then have not been able to get a backup from the machine. The error message...