Network Management

hi ppl,Im implementing event manager in my routers to send a mail when the downstream of the adsl is below 512k.but i have a problem the router cant reach the mail server because the request must be made using the loopbackBecause when is making the r...

Hi..1> I have cisco 4000 router, Version 11.2(16).Router is going ver slow.There is no ACLs,not any routing protocls,only statis routes are there.What can be the cause??Every time there is high %age of IP Input process.2> I want to upgrade its IOS.Fr...

As above how dio I do this ?, the admin password was changed not documented and now forgotten :-(RegardsScott

Hi,We created an immediate job but it fails several times. We already checked the credential that LMS has and it is the same with what the device has. Also I have checked the connection of the device to the LMS and it is connected. I checkd the snmp ...

I am experiencing intermittent issues with DCR service (Error in communicating with DCA Server), I shutdown and restart the daemon manager, DCR service finally comes up however several days later it goes down again. I do not have any anti-virus softw...

Is there an option in LMS 2.6 to auto-discover adjacent devices using pre-set SNMP and/or logon creds?This would cut down on the manual adding of new devices. thanks

I'm not sure how this was enabled in the first place but every time I go into config mode on a router or switch, cisco works detects a change in the config and logs into the network device to backup the config. I want to stop this and run a job afte...

I need to search all my routers to see who has the GRE tunnel flapping. I want to use Common Services/LMS to find %TUN-5-RECURDOWN: Tunnel10 temporarily disabled due to recursive routing. How do I do that?Thanks!Matt

DFM installation adds "set ip:do_tcp_fusion=0x0" to the /etc/systems file.Since in my case this happens inside a nonglobal zone, this has no effect.I could not find any documentation about this, so what's the purpose of this change? Is it still neede...

HiI have configured Common Services to use AD - ldap authentication. And it works but now after logon, I don't have sufficient privileges to change anythings in CiscoWorks (for instance I can't change aaa parameters now). Is another way to logon loca...

We run LMS 2.6 on Solaris 8Recently we purchased the C3560 8 port switch from Cisco. When I look in device type groups, only the 24p version is available, even after doing a device update only the 24p version is available, the 8p version is classifie...

Hi,I ask for some qualification please.My customer has 5000+ devices and wishes to populate the 'snmp-server chassis-id' with serial no.s of each device.I'm thinking of exporting the serial no. into an XML file and using that file for the Parameteriz...